You are here

Interpretation Response #PI-95-007

Below is the interpretation response detail and a list of regulations sections applicable to this response.

Interpretation Response Details

Response Publish Date: 03-06-1995

Country: US

View the Interpretation Document

Response text:



Date of Issue: March 6, 1995

49 CFR Section(s): 192.283(a)

Subject: Heat fusion joining procedures

I am replying to your letter of January 9, 1995, concerning heat fusion joining procedures that have been qualified for use on pipe made by a particular manufacturer from an ASTM classified material with a certain melting index. You asked if these procedures may be used without further qualification on similar pipe of other manufacturers. According to your letter, the Maryland Public Service Commission has advised you that joining procedures must be separately qualified for each manufacturer.

Under 192.283(a), heat fusion joining procedures must be qualified by performing certain physical tests on pipe specimens. Because these tests are based on particular pipe characteristics, a qualified procedure may be used only to join pipe that has those same characteristics. As your letter indicates, the characteristics of similar pipe may vary somewhat from manufacturer to manufacturer. In these circumstances, a single joining procedure may be used to join similar pipe of different manufacturers, but the procedure must be qualified by testing samples of each manufacturer's pipe.


Cesar De Leon
Deputy Associate Administrator
for Pipeline Safety

Regulation Sections

Section Subject
§ 192.283 Plastic pipe: Qualifying joining procedures